The passenger who rings back looking for a receipt for expenses. Reprint the last job, or any of the last ten.
ATA Taximeter – Irish market firmware – Pulsar Europe – PRIMUS RS-01 & S-01 – 2026
Reprinting the receipt for the job you have just finished is one button. Going back and finding an earlier job is a short trip through the menu. Both are below.
The last ten completed jobs are held in memory and can be reprinted by date. The eleventh pushes the oldest out, so if a passenger is going to look for a receipt, sooner is better than next week.
To save you scrolling, the meter remembers the last menu you were in. Press Button 3 from "FOR HIRE" and it will offer that same menu again first. If nothing is pressed for 10 seconds it drops back to "FOR HIRE" on its own.
The print has not completed. Check the thermal roll is in the right way round and has not run out — a roll gives over 350 receipts, so it is easy to forget about until it goes. If the paper is fine and it still will not print, ring Pulsar Europe on +353 87 283 5120.
Stuck? Call Pulsar Europe on +353 87 283 5120.
Prints to a single A4 sheet. Stuck? Call Pulsar Europe on +353 87 283 5120.